PROEL LED POWER RGB, User Manual, Page: 25 / 34

- DM.ST
: (leds state when DMX signal isn’t received). When the board is switched on and DMX signal is missing,
the board can do this functions: black-out, leds on at 15% or led on at 100%.
Default value
15.ON
Go to this submenu pushing Mode , choose
DM.ST
with + and - and push Enter . Use + and - to select the desiderate
value and push Enter to confirm
Admissible mode:
15.ON , (15% ON) r,g,b,a channels ON at 15%
A.ON , (ALL ON) r,g,b,a channels ON at 100%
A.OFF , (ALL OFF) r,g,b,a channels OFF
-
MA.IR
: (master infrared) Whit I.R. sensor cabled, the board can run one of the stored Chase or do a fixed colour,
that can be controlled by the LED REMOTE.
LED REMOTE has 10m (free air) capacity.
Default value ON
Go to this submenu pushing Mode , choose MA.IR with + and - and push Enter . Use + and - to select the ON or OFF
and push Enter to confirm.
With red button of the LED REMOTE, you can switch ON or OFF the leds (ATTENTION: when you switched OFF the
led, the board is still running!!! ), with P+ e P- you can choose the program or change the colour. This function allows
to use the MASTER/SLAVE function.
ATTENTION:
Disable
MA.IR
function on Slave boards. Two boards in Master mode can do several errors on DMX
transmission.
- ST.AL
:
(stand alone) The board can run in StandAlone mode with Master/Slave function.
Default value MS00
Go to this submenu pushing Mode , choose
ST.AL
with + and - and push Enter . Use + and - to select the macro
needed and push Enter to run it.
The board run in loop mode the Macro selected from M01 to M26 and output the DMX signal (master mode) for the
other board (slave).
To use Master/Slave function, all the boards need to be patched with the dmx patch 7C d !
StandAlone mode remains also if power supply is interrupted.