Storage
The power supply, in its original packing, must be kept in covered, dry areas with a temperature between –10°C and
+50°C. Attention, the projector will be damaged during the unpacking
Admissible environmental conditions
The power supply was engineered and produced to function in in-door areas with an air temperature ranging between -
10° and +30°C and with a humidity level between 30 and 90%.
When choosing the installation, please make sure that the device is not exposed to extreme heat or in small area.
Installation
The power supply is studied for ceiling, false ceiling, wall installation or similar structures.
Led Power RGB has 4 fixing holes diameter 4mm. Use this holes to fix the power supply, distance of holes is
293x44mm.
Connect the projector to the power unit using the projector cable with RJ45 connector.
Example of installation
If only one Led Power RGB is on stand alone mode the signal cable is not necessary.
If the Led Power are driven by a DMX controller or Led Power Master drive other Led Power Slave, they need to be
connected together, with DMX signal cable, following the instructions of this manual.
The DMX signal is generated by a DMX controller, the signal cable goes in and out from each power unit up to the last
one.
More Led Power RGB will execute the same scenes if the DMX addresses are the same (factory set is 1) or they can be
driven one by one if the DMX addresses are different from each other.
In the pictures below, projector is Led Power RGB
Default mode
7C d
: each projector uses 8 DMX channels
If the DMX controller is not switched on, the projectors can be in black-out mode, generate light at 15% (default
setting) or generate light at 100%. Change this parameter at – DM.DE of menu.
It is possible to use MASTER/SLAVE function: One projector (Master) functioning in stand alone mode with resident
programs and a group of projector (Slave) execute, thanks to dmx signal and signal cables, the same sequences of
colours.
The projectors can be fed from different power sources, it is not necessary to switch on the projectors at the same time.