PROCRAFT SPI 320, User Manual

Page: 15 / 55

EN | ENGLISH
15
Arc radiation can harm your eye and cause contract with
hot workpieces to burn.
Use a suitable helmet and light filter, wear protective
clothing to protect your body as well. Use a suitable
helmet or darkening to allow good visibility.
Extreme volume can cause hearing damage!
Use ear protectors or other aids to protect the ear. Noise
above 70 dB can cause hearing damage.
Risk of explosion! Apparently harmless substances in
closed containers can build up overpressure by heating!
• Remove containers with flammable or explosive
liquids from the working area!
• Do not heat explosive liquids, dusts or gases by
welding or cutting!
ATTENTION
Obligations of the operator! In the European Economic
Area (EWR), the respective national implementation of
the framework guidelines must be complied with and
observed!
•
National implementation of the Framework
Directive (89/391/EWG) an d the related individual
directives.
• In particular, Directive (89/655/EWG) on the
minimum health and safety requirements for the
use of work equipment by workers at work.
•
The accident prevention regulations of the
respective country (for example in Germany the
BGV D 1)
• Check the safety-conscious work of the user at
regular intervals! Damage caused by foreign
components! The manufacturing guarantee
expires in case of equipment damage caused by
external components!
•
Only use system components and options (current
sources, welding torches, electode holders, remote
control, spare and war parts, etc.) from our product
range!
•
Connect the accessory component to the
connection socket only when the power source is
switched o ff and lock it! Electromagnetic
interference! According to IEC 60974 - 10 the
devices are intended for use in industrial areas. If,
for example, used in residential areas, difficulties
can arise if electromagnetic compatibility is to be
endured.
• Check the influence of other devices!
1- 1.8.5/8 inches
1. Wire reel
2. Wire for electric welding
3. Wire guide inlet
4. Pressure regulator
5. Drive roller
6. Exit of the guide wire
7. Welding torch tube cable
Lay gun cable right before installing wire