PRODMHD11 Manual V1.1
9
Procedure to connect to the Encoder via the Web Management port
The following procedure will allow the installer to setup the Encoder via the GUI
(Intranet setup- closed LAN setup)
1.
Power up
the Encoder
Connect each encoder using a standard CAT5e cable from the Web Management port (located on
the rear panel of the encoder) to a switch. Connect a CAT5e cable from the switch to a PC.
2.
Set
the PC via the Control Panel to
“Obtain an IP address automatically”
Start- Control Panel
View Network Status and Tasks
3.
Select
'Change Adapter Settings' from the left plane
