PRODMHD11 Manual V1.1
7
MODULATOR SETUP AND CONFIGURATION
INITIAL SETUP TO FACTORY DEFAULT
The digital modulator’s front panel is used to configure the modulator as desired.
MODULATOR CONFIGURATION
Once the modulator is powered up it will go through an internal booting process. When the booting process is
finished,
the LCD Display shows the default Channel number and LCN.
There are two parameters to setup, Channel number and LCN. For switching between the two parameters, press OK
button until the arrow flashes. Press UP/DOWN button to select the desired setup parameter. Then, press OK again
to confirm.
Output Channel
– Use the Scroll Up/Down button to change the output channel. Available channels are depending
on the local system. The Output Channel is default to E64 (818 MHz). Once the desired output channel is selected
press the OK button to set the channel.
LCN –
Use the Scroll Up/Down button to change the LCN. The LCN default value is 101. Once the desired LCN is
selected press the OK button to set the LCN.
