ENGLISH
11
5. Clean the air filter elements if they are to be reused.
Paper filter element: Tap the filter element several times on a
hard surface to remove dirt, or blow compressed air [not
exceeding 207 kPa (2.1 kgf/cm
2
, 30 psi)] through the filter
element from the inside. Never try to brush off dirt; brushing
will force dirt into the fibers.
Foam filter element: Clean in warm soapy water, rinse, and
allow to dry thoroughly. Or clean in non-flammable solvent and
allow to dry. Dip the filter element in clean engine oil, and then
squeeze out all excess oil. The engine will smoke when started
if too much oil is left in the foam.
6. CYCLONE TYPE ONLY: Tap the air cleaner cover several times
on a hard surface to remove dirt, or blow compressed air [not
exceeding 207 kPa (2.1 kgf/cm
2
, 30 psi)] through the air
cleaner cover from the outside.
WING NUT
AIR CLEANER COVER
CYCLONE DUAL-FILTER ELEMENT TYPE
WING NUT
PAPER FILTER ELEMENT
FOAM FILTER ELEMENT
GASKET
Clean
Squeeze and dry
Dip in oil
Squeeze
Do not twist.
Do not twist.
7. Wipe dirt from the inside of the air cleaner case and cover using
a moist rag. Be careful to prevent dirt from entering the air duct
that leads to the carburetor.
8. Place the foam air filter element over the paper element, and
reinstall the assembled air filter. Be sure the gasket is in place
beneath the air filter. Tighten the wing nut securely.
9. Install the air cleaner cover, and tighten the wing nut securely.
Oil-Bath Type
1. Remove the wing nut, and remove the air cleaner cap and
cover.
2. Remove the air filter element from the cover. Wash the cover
and filter element in warm soapy water, rinse, and allow to dry
thoroughly. Or clean in non-flammable solvent and allow to dry.
3. Dip the filter element in clean engine oil, then squeeze out all
excess oil. The engine will smoke if too much oil is left in the
foam.
4. Empty the used oil from the air cleaner case, wash out any
accumulated dirt with non-flammable solvent, and dry the case.
5. Fill the air cleaner case to the OIL LEVEL mark with the same oil
that is recommended for the engine (see page 8).
Oil capacity: 60 cm
3
(2.0 US oz, 2.1 Imp oz)
6. Reassemble the air cleaner, and tighten the wing nut securely.
Clean
Squeeze and dry
Dip in oil
Squeeze
Do not twist.
Do not twist.
AIR CLEANER
COVER
AIR FILTER
ELEMENT
GRID
WING NUT
CAP
AIR CLEANER
CASE
OIL LEVEL
37Z4V6000.fm Page 11 Tuesday, March 7, 2017 3:24 PM
