Tip:
Before placing your boat in the water, secure
the canopy on the hull. Apply clear tape (DYNM0102)
around the canopy seam, if desired.
1. Carefully place the boat in the water.
2. Operate the boat at slow speeds near the shoreline.
Avoid objects in the water at all times. When the
boat is moving forward, ensure water flows out of
the coolant outlet. Remove any blockage from the
rudder inlet and coolant system or the motor and ESC
(electronic speed control) may overheat.
3. Once you are comfortable operating the boat at slow
speeds, it is safe to operate the boat farther from the
shore.
4. If the boat does not go straight, adjust the steering
trim dial on the transmitter.
Tip:
If you are using excessive steering trim on your
transmitter to make the boat drive straight, return the
trim to neutral and mechanically center the rudder. To
do this, use a 1.5mm hex driver to loosen the set screw
holding the push rod to the servo. Adjust the linkage in
or out of the brass barrel until the rudder is centered.
Tighten the set screw using a 1.5mm hex driver.
5. Bring the boat back to shore when you notice the
boat starting to lose speed.
6. Power off the ESC and disconnect the battery packs.
7. Allow the motor, ESC and battery packs to cool before
charging the batteries or operating the boat again.
NOTICE:
Always power OFF the receiver before
powering OFF the transmitter. If the transmitter is
powered OFF before the receiver, the receiver will
enter failsafe mode.
Testing Your Boat in the Water
Control Check
IMPORTANT:
Perform a control check at the beginning
of each boating session, after repair or after installation of
new batteries.
Ensure the receiver antenna is extended properly and all
batteries are fully charged.
1. Power ON the transmitter and the boat.
Do not
install the boat canopy.
2. Place the boat securely on the boat stand.
NOTICE:
Do not operate the engine without water
cooling circulation or damage may result.
3. Check steering and throttle on the transmitter.
8
EN
UL 19 Hydroplane
