The included transmitter and receiver are bound at
the factory.
If you need to rebind, follow the instructions
below.
1. Ensure the transmitter and vehicle are both powered
OFF.
2. Install the bind plug in the BIND/battery port of the
receiver.
3. Power ON the vehicle. The receiver LED will blink.
4. Stand approximately 8–12 feet (2.4–3.7m) from the
vehicle. With the steering wheel and throttle trigger
in the failsafe positions (neutral), press and hold
the bind button and power ON the transmitter. The
transmitter's green LED will blink after 3 seconds,
indicating it is in bind mode.
5. Release the bind button when the green LED flashes.
Continue holding failsafe positions until the binding
process is complete.
6. The receiver LED will glow solid when the transmitter
and receiver are bound.
7. Power OFF the vehicle, then the transmitter.
8. Remove the bind plug and store it in a convenient
place.
The receiver will be bound to the transmitter until
another bind process is completed.
If you encounter problems, obey binding instructions
and refer to the troubleshooting guide for other
instructions. If needed, contact the appropriate Horizon
Product Support office.
NOTICE:
Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in
bind mode within 400 feet. Doing so may result in
unexpected binding.
Failsafe
In the unlikely event that the radio connection is lost
during use, the receiver will drive the servos to their pre-
programmed failsafe positions as set during Binding.
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode.
When the transmitter is powered on, normal control is
resumed.
IMPORTANT:
Failsafe activates only in the event
that signal is lost from the transmitter. Failsafe will
NOT activate in the event that receiver battery power
decreases below the recommended minimums or
power to the receiver is lost.
Getting Started
1. Power on the transmitter.
2. Connect the two batteries to the
EC5™ connectors on the ESC.
3. Power on the ESC switch. The
ESC arming tones will sound.
4. Test the transmitter’s control of
the boat with the boat on the
display stand.
Binding
7
EN
30-INCH READY-TO-RUN BRUSHLESS BOAT
2
3
1
X2
4
