Instruction Manual
Battery Charger
This light and compact charger (DYN4113) quickly and
easily charges 5–8 cell Ni-MH battery packs with an
installed EC3
™
power connector.
Instructions
1. Connect the AC power cord to the power slot on
the charger, then connect the other end of the
power cord to an AC power source.
2. The Power LED and Charging LED will turn
GREEN when the charger is connected to
the AC power source.
3. Connect the battery pack connector to the
charge connector.
4. Press the On/Off button to charge the battery.
The Charging LED turns RED.
5. When the battery pack is fully charged, the Charging
LED will turn GREEN.
6. Press the On/Off button to stop charging. Disconnect
the battery pack connector from the charge connector.
CAUTION:
If at any time during the charge
process the battery pack becomes hot to
the touch, unplug the battery immediately
and discontinue the charge process.
5
EN
Antenna Installation
1. Apply clear tape to the antenna (A) and hull in the
decoy to keep the antenna from moving.
2. Feed the antenna through the grommet (B) on the
clear hull cover (C) and antenna tube (D).
3. Put the antenna tube through the hole in the decoy
body.
Tip: Ensure the antenna wire is as straight as possible
before inserting the wire in the tube.
Transmitter Battery Installation
This transmitter requires 4 AA batteries.
1. Remove the battery cover from
the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
B
A
D
C
