Control Check
IMPORTANT:
Perform a control check at the beginning
of each boating session, after repair or after installation of
new batteries.
Ensure the receiver antenna is extended properly and all
batteries are fully charged.
1. Power ON the transmitter and the boat.
Do not
install the boat canopy.
2. Place the boat securely on the boat stand.
NOTICE:
Do not operate the engine without water
cooling circulation or damage may result.
3. Check steering and throttle on the transmitter.
Servo Travel
The servo travel on the Steering and Throttle channels can be adjusted through a special programming mode in the
transmitter.
1. Begin with the transmitter binding process to the receiver complete. Power ON the receiver.
2. Hold full right and full brake while powering the transmitter ON to put the transmitter into programming mode.
The LED on the transmitter will flash 4 times to indicate it is in programming mode.
3. Turn and hold the wheel full left to set the travel limit for that direction, Press the A button to increase travel, press
the B button to reduce travel. The LED will flash once with every change. Return the wheel to center to set the
travel value.
IMPORTANT
: If the value has reached the maximum or minimum that can be accepted, the LED will not flash with
further input.
4. Turn the wheel to the right and repeat the process to set the steering travel to the right.
5. For electric vehicles, power the Transmitter OFF to save the settings. Calibrate your ESC to the default throttle
travel.
6. For fuel powered vehicles, set the throttle travel without the engine running; After setting steering travel, you can
set throttle travel with the same process. Pull and hold full throttle, adjust travel with the A and B buttons, return
to center to set the value.
7. Push full brake, adjust travel with the A and B buttons, return to center
8. Power the transmitter OFF to save the values.
9
EN
29-INCH READY-TO-RUN BRUSHLESS CATAMARAN
