Antenna Tube Installation
1. Carefully feed the end of the receiver antenna through the
grommet inside the hull.
2. Pull the antenna wire out of the grommet toward the outside
of the boat, then slide the antenna through the antenna tube.
3. Insert the tube into the grommet, then fit the cap onto the
tube.
4. Slide the clear 20mm silicone cooling line over the grommet
and hull and install the tube into the silicone cooling line.
The antenna must be installed above the boat’s waterline to get
the best reception of your transmitter’s signal.
NOTICE:
Do not cut or kink the receiver antenna or damage
may result.
Boat Stand Assembly
1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the
side stand to the ends.
3. Allow the adhesive to dry before placing your boat
on the stand.
4
EN
®
Product Inspection
Carefully remove the boat and radio transmitter from the box. Inspect the boat for damage. If your product is
damaged, please contact the hobby shop where you purchased your boat, or contact Horizon Hobby Product
Support. Refer to the Warranty and Service Contact Information section for more info.
Recommended Tools and Materials
• (2) Spektrum 7.4V 5000mAh 2S 100C Smart Hardcase LiPo
Battery: IC5 (SPMX50002S100H5)
-or-
(2) Spektrum 11.1V 5000mAh 3S 100C Smart Hardcase LiPo
Battery: IC5 (SPMX50003S100H5)
• Spektrum Smart S2100 AC Charger, 2x100W (SPMXC1010)
• Needle nose pliers
• Paper
towel
• Rubbing
alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 4mm, 7mm, 8mm
• Phillips screwdriver: #1
• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm
• Clear tape (DYNM0102)
• Dynamite
®
Marine Grease and Gun (DYNE4200)
• Hook and Loop Tape Set, WP 4pcs (DYNK0300)
