Drivetrain Lubrication
Always replace the drivetrain parts when they are damaged
or show visible wear or injury and damage may result.
Lubricating the flex shaft is vital to the life of the drivetrain.
The lubricant also acts as a water seal, keeping water from
entering the hull through the stuffing tube.
Lubricate the flex shaft and propeller strut after every 30
minutes of operation and/or everytime you change the
batteries.
1. Inside the hull, use 2 10mm open-end wrenches to
loosen the collet nut from the flex shaft.
2. Slide the flex shaft out from the stuffing tube and drive
strut at the rear of the boat.
3. Wipe the old lubricant and material from the flex shaft.
Tip:
Use motor spray (DYN5500) to break down the
grease buildup.
4. Lubricate the full length of the flex shaft assembly
up to the drive dog using Dynamite Marine Grease
(DYNE4200). Also apply grease to the collet threads.
5. Carefully reinstall the flex shaft in the drive strut, stuffing
tube and collet. If the flex shaft is difficult to remove
from (or install into) the collet, rotate the flex shaft to the
right while pulling it from (or inserting it into) the collet.
NOTICE:
Do not rotate the flex shaft to the left inside the
coupler.
Ensure there is a 2mm gap between the drive strut and
drive dog to allow for flex shaft shrinkage under load.
NOTICE:
Running the boat in saltwater could cause some
parts to corrode. If you run the boat in saltwater, rinse it
thoroughly in freshwater after each use and lubricate the
drive system.
NOTICE:
Because of its corrosive effects, running RC boats
in saltwater is at the discretion of the modeler.
1. Pull and hold the Throttle Trigger to full throttle and
turn the ESC on.
2. After 2 seconds a
“-B-B”
will sound. Wait another
5 seconds and the ESC will give a rising tone to
indicate you have entered
Programming Mode
.
3. After entering Programming Mode, you will hear 4
tones in a loop indicating
Programmable Items
. Push
the Throttle Trigger to full brake within 3 seconds
after the tone sounds matching the programmable
item you want to select.
4. After selecting a programmable item, you will hear
several tones in a loop indicating
Programmable
Values
. Pull Throttle Trigger to full throttle to select
the value matching the tone. The ESC will give an
alternating tone to indicate the item is selected.
5.
Keep the trigger in Full Throttle to return to
Step 3
and continue item selection. Move the throttle stick
to full brake position within 2 seconds to exit the
Program Mode.
The black-shaded setting is the factory default
Programmable
Items
Programmable Value
-B
Single Beep
B––
Long Beep
-B
-B-B
-B-B-B
-B-B-B-B
B––
B––
-B
B––
-B-B
B––
-B-B-B
Running Mode
-B
Forward
Only
Forward/
Backward
Li-Po Cells
-B-B
Auto
Calc.
2s
3s
4s
5s
6s
Low Voltage Cutoff
-B-B-B
None
2.8V/Cell
3.0V/
Cell
3.2V/Cell
3.4V/
Cell
Timing
-B-B-B-B
0.00º
3.75º
7.50º
11.25º
15.00º
18.75º
22.50º
26.25º
Transmitter Programing
13
EN
29-INCH READY-TO-RUN BRUSHLESS CATAMARAN
