PROALL G Series, Operator'S Manual

Page: 51 / 59

MX05001
7-9
Rev.
1
3 March 2022
Lubrication and Maintenance Frequency
Table 7. Frequency Table
Notes:
A. Refer to the Take Up Bearing section on page
7-1 for the correct gap setting.
B. Clear brush off debris and replace it if worn.
C. Purge the seal of mix residue immediately
after cleanup. Ensure the auger is running
while applying grease.
D. Check the return filter gauge. Ensure the
indicator shows green while the mix auger is
running. Refer to the Hydraulic Oil Filter
section on page 7-2.
E. Use SAE 30 weight oil or similar. For chain
oiler reservoir, fill chain oil to the base of the
filler neck. Fill as needed.
F. Check that the oil level is showing in the sight
glass. Refer to Oil Specifications section on
page 7-1 for correct hydraulic oil.
G. The filter is located within the tank. A visual
inspection of the filter will be required to
ensure the filter is not clogged.
Maint.
Item
Number
No.
Points Daily
Every
1
Load
Every
20
Hrs
Every
50
Hrs
Every
500
Hrs
1 1 Rear conveyor shaft grease, right •
2 2 Front conveyor shaft grease, right and left •
2 2
A
Rear conveyor shaft sensor gap check •
3 1 Cement bin sump bearing grease •
4 2
B
Chain brush check, left and right •
5 1 Mix auger top bearing grease •
6 1 Upper rear link grease •
7 1 Lock arm grease •
8 1 Lower rear link grease •
8 1 Boom cylinder grease •
9 1 Auger bottom bearing grease •
9 2
C
Auger bottom bearing grease •
10 1 Rear conveyor shaft grease, right •
11 1
B
Cement bin sump brush check •
12 1
D
High pressure hydraulic oil filter check •
13 1
E
Maintain conveyor chain oil level •
14 1
F
Hydraulic oil level check •
14 1
G
Hydraulic return filter check •
14 1
G
Hydraulic suction filter check •
1 Hydraulic Oil Replace •