8
Rotating Selector Code Table:
00 – Manual dimming
01 – DMX channel 1 – Light 1 dimming
02 – DMX channel 2 – Light 2 dimming
03 – DMX channel 3 – Light 3 dimming
04 – DMX channel 4 – Light 4 dimming
…
…
…
…
99 – DMX channel 99 – Light 99 dimming
NOTE 1: DMX electrical signal is received from DMX
-
IN connector and amplified, then sent
through DMX
-
OUT connector to next light equipment. This way each light equipment is
functioning as a DMX Repeater. The mentioned feature provides a long single DMX signal branch
connections (up to 99 lights) at long distances.
In case when the current light equipment is in Power Down condition, then a special By
-
Pass relay
provide input signal to the output (not amplified); this way all the connected light equipment
devices continue to function with full DMX features.
NOTE 2: The DMX signal circuitry is fully electrically insulated from the internal circuit of light.
This way no hazard or influence of the electrical circuit in any light equipment could spoil the
voltage potentials of DMX connecting cables and wires.
NOTE 3: The thermal management of the light is based on sensing a high temperature (+65°C
inside the light), when the RED front LED goes to ON conditions. In such a condition, use of the full
power is no more recommended –
please decrease the power at least with 20%, due to the higher
environment temperature.
In case temperature is higher than the described limit (+75°C inside the light), the emergency OFF
condition is effectuated and lamp goes to OFF mode (RED LED is still ON). In such a case, leave the
light to become cool or take it away from hot environment, and then the function will be restored.
General Maintenance and Care
When not in use, Sunfire Light should be stored in a dry and dust-free area. General Maintenance
and Care consists of making sure that the light always has good ventilation and that nothing is
obstructing free air flow through and around the light. Do not use chemicals to clean it. Any
cleaning of the light, especially LED optics, should be with a damp (not wet) soft cloth, which is
non-abrasive.
