6
Assembling
Make note of the location of inputs and
outputs along with light controls found
on its Control Box, as shown.
Unpacking Instructions
Immediately upon receipt of this light, carefully inspect the packaging for any
obvious signs of damage from mishandling or exposure to elements. If any is noted,
please provide this information to the shipper immediately so that proper claims
can be processed. Place packaging in upright position (with labelling and markings
in readable orientation) and open the top end of carton. Remove the light and
associated material from carton and place them on a stable surface or mounting
configuration using the provided yoke and yoke pin mounting system.
NOTE: The AC & DC Power Cables will be found tie
-
wrapped & coiled
-
up inside the yoke attached
to the power supply, inside the shipping container.
Uncoil the AC and DC Cord, plugging the DC female end into DC power input, located on back
of Control Box (shown above).
NOTE: Lights operate on grounded 110v –
240v, 50/60Hz AC Input. AC Supply Source must be
sized properly and has approved protection circuitry for safe operation. Take care to observe
all proper precautions when connecting power.
NOTE: If the external flexible cable or cord of this light is damaged, it shall be exclusively
replaced by contacting us or a similar qualified person, in order to avoid hazards.
Plug the male end of AC Power Cord into an appropriate AC power source.
Turn on the Light by pressing Power Switch, located at the back of Control Box.
