Operating instruction RAPTOR 4all & 4you
17
Figure 27: Quick release lever opened for adjusting
the neck rest angle
After every adjustment, check that the
neck rest is firmly attached in its position. If
necessary the tension can be adjusted by
turning the nut of the quick release lever
clockwise until it reaches the end stop.
Figure 28: Nut of the quick release lever
20 Collision guard
Figure 29: Collision guard
20.1 Collision guard mount
The removal of the collision guard is carried
out via the quick pins. To do this, press the
locking knobs of the quick pins on the right and
left and pull these out. Then the collision guard
can be pulled out.
Figure 30: Quick Pin with locking knob for removing
the collision guard
After removing the collision guard, the
Quick Pins can then be inserted in the
boreholes of the inlets or the collision guard to
prevent losing them.
20.2 Mounting the collision guard
Figure 31: Inlet of the collision guard with borehole
For mounting the collision guard, the collision
guard is pushed onto both inlets to the stop.
Then the Quick Pins are inserted back into the
boreholes of the collision guard and inlet with
the locking knobs pressed. In doing so, take
care that the locking knob jumps back out
completely after inserting.
Top quick
release lever
opened
Locking knob
Inlet
Nut of the quick
release lever
