16
CD15718
E
N
G
L
IS
H
OPERATION
When indicator is just past 21, output is at maximum before it is disengaged.
This is useful in driving screws into different types of material.
More torque will set a screw deeper into material, less torque will prevent it
stripping. Larger screws require more torque to drive than small ones. A little
trial and error will show you which is the optimum setting for the situation.
Release the trigger when the clicking sound indicates the chuck will not turn
further.
For drilling, always use the drill setting, indicated by the pictogram of a drill bit.
At this setting, the drive does not disengage from the chuck.
BATTERY PACK
IMPORTANT !
The battery is not fully charged. Before first use, the batte
ry pack requires 8-
10 hours charge time to be fully charged. Subsequent recharging needs 3-5
hours for the battery to be fully charged.
Always switch to a fresh battery when tool performance begins to diminish.
Severe heat is most destructive to a battery; the more heat
generated,
the faster the battery loses power. A battery that gets too hot can have a
shortened life.
Never over-discharge a battery by using the tool even after tool performance
has decreased. Do not attempt to discharge a tool’s battery by continuing to
pull on the tool trigger
. When tool performance begins to diminish, stop the
tool and recharge the battery for optimal performance.
Batteries will reach full performance after about five charge
/discharge cycles.
Always have drill rotation switch in neutral/lock position when removing or
inserting battery to avoid unintentional starting.
To remove battery pack from the tool, press the lock spring buttons (J in the
functional description) and pull out.
To insert, simply push pack in until lock spring clicks.
The battery charger consists of two parts:
1. a combined transformer / 120 volt plug with a low-voltage lead
2. a charging stand
To charge, connnect the transformer/plug low-voltage lead to the charging
stand.
Insert the transformer/plug into a 120V household current receptacle.
The step of the battery pack has positive and negative terminal markings on
it. Align these with the identical markings on the top of the charging stand and
insert pack into base (Pack will not insert properly if reversed)
The red light is the charge indicator. When the charger is connected to AC
household current, the red light remains off.
When the battery is properly inserted into the charger and charging, the red
light is on.
Normal charging time is 3 to 5 hours. The charger will charge the battery at the
normal rate until charging is complete. After the battery is fully charged according
to the charging time provided in the instructions, remove the battery pack from the
charging stand immediately. Battery temperature will cool to normal.
When charging more than one battery pack, allow 15 minutes between
charges.
The battery discharges slowly over time, even when not used, and may require
recharging before you use the tool.
After many charge/discharge cycles, your battery will lose its ability to hold
a charge. It should then be replaced. Dispose of batteries at an appropriate
waste disposal facility. They contain cadmium, so do not throw batteries away
in common trash receptacles.
!
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
