d. Reinsert the dipstick and either press firmly to hold in place or
screw the oil fill cap hand tight.
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil
to ensure that it is suitable for the engine.
1.
Remove the oil filler cap and place to one side.
2. Place a funnel into the oil fill neck. The funnel opening should be
wide enough to prevent the oil from collecting in the funnel’s cone.
3. Pour oil into the funnel. Allow the oil to settle for one minute and
recheck the level. Repeat until the desired level is reached.
4. Insert the oil filler cap and hand tighten.
5. Wipe up any spilled oil. Dispose of oil soaked rags in a proper
hazardous waste container.
IMPORTANT! Used oil must be disposed of properly. Do not
pour it on the ground, down a drain or throw it in the trash.
Take the oil to your local recycling centre or a service
station for reclamation.
HOW TO DRAIN OIL
WARNING! Do not tip the engine while draining. This can
cause fuel to leak into the oil compartment, creating a
potential fire hazard. If this is unavoidable, drain the fuel
from the engine before draining the oil.
1.
Remove the dipstick.
2. Place an approved container below the oil
drain plug.
3. Remove the oil drain plug and allow oil to the
drain into the approved container.
4. Install oil drain plug and tighten with a wrench.
IMPORTANT! Used oil must be disposed
of properly. Do not pour it on the ground, down a drain or
throw it in the trash. Take the oil to your local recycling
centre or a service station for reclamation.
Fig. 3
V1.0
4,5000W GASOLINE INVERTER GENERATOR
8953176
Page 15
Assistance available at www.princessauto.com or 1-800-665-8685
