V1.0
Metal Cutting Scroll Saw
8896235
Visit www.princessauto.com for more information
13
INSTALLING BATTERIES IN LED LIGHT
1. Remove the screws from the LED lamp’s (A) battery cover. Set the
cover aside.
2. Align each AA battery’s polarity correctly and insert both into lamp.
3. Reattach the battery cover and secure with the screws.
OPERATION
DANGER! Do not try to remove splinters, chips, or jammed
material while the machine is running. Allow the machine to
come to a full stop and switch off the main power switch before
attempting to do so.
ON/OFF SWITCH WITH KEY
The ON/OFF switch with key (H) is located on the front of the scroll
saw. Press the switch up to turn the power ON. Push the switch down to
turn the power OFF.
Remove the yellow key from the switch when you are finished working
with the scroll saw. The power switch will not work
without the yellow safety key in place. The safety key
can only be removed when the power switch is in the
OFF position.
Make sure the key is removed from the ON/OFF switch
(H) to prevent an accidental start when adjusting or
repositioning any part of the scroll saw.
SET THE BLADE TENSION
1. Lift the blade guard (B) out of the way.
2. Gently press against each side of the saw blade. A slight deflection
without moving the saw blade ends is correct. Too much deflection
may allow the blade to drift during a cut. No deflection might cause
the blade to break during use.
3. Turn the blade tension lever (Q) clockwise to increase the tension
and counterclockwise to loosen the tension. Check the saw blade
while adjusting until the tension is correct.
Fig. 5