![background image](http://html1.mh-extra.com/html/pro-point/8699183/8699183_user-manual_1607423010.webp)
8699183 VARIABLE SHADE AUTO-DARKENING WELDING HELMET
V1.0
10
For technical questions call 1-800-665-8685
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
FRONT COVER LENS REPLACEMENT
Replace the front cover lens (#3) if it is damaged (cracked,
scratched, pitted or dirty). Remove the old front cover lens by
pressing two lock switches at the bottom of the retaining frame
(#7) and pull the frame and ADF (#5) out. Take the old front
cover lens out and remove any protective film before installing
the new one.
INSIDE COVER LENS REPLACEMENT
Replace the inside cover lens (#6) if it is damaged (cracked,
scratched, pitted or dirty). Place your finger or thumb into the
recess and flex the inside cover lens upwards until it releases
from one edge. Then remove any protective film before
installing the new one.
BATTERY REPLACEMENT
When low voltage indicator (A) turns red, change the battery.
Slide the cover plate off the battery compartment (B). Remove
the battery and replace with a new CR2450 battery. Slide the
battery compartment cover back in place. The LED should
remain dark while the helmet is in use.
CLEANING
NOTICE! Do not use alcohol, gasoline or diluents to clean the
filter cartridge. Do not put place the filter cartridge into water
as this will damage the filter.
Clean the lens, helmet shell and headband with a soft cotton cloth
and mild soap. Replace the headband when required.