![background image](http://html1.mh-extra.com/html/pro-point/8699183/8699183_user-manual_1607423007.webp)
V1.0
Variable Shade Auto-Darkening Welding Helmet
8699183
Visit www.princessauto.com for more information
7
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included
Parts List. Letter references in parenthesis (A) refer to the
included Identification Key. Dashed numbers in parenthesis
(Fig. 1-1) refer to a specific point in an illustration or image.
The welding helmet comes preassembled.
ADJUST THE WELDING HELMET FIT
The headband should be adjusted both in diameter and height.
The angle between face and helmet should also be adjusted
(recommended 10° to 12°).
1. Adjust the headband diameter with the twist knob on
the headband (Fig. 2-1). Twist clockwise to tighten and
counterclockwise to loosen.
2. Adjust the helmet shell (#1) height by snapping the pin into
the hole to lock securely in place (Fig. 2-2).
3. To adjust the viewing angle, loosen the knob on right side of
the helmet (Fig. 2-3) and change angle locker to the desired
tilt position (5 positions). Once achieving the desire angle,
tighten the knobs until snug. The helmet should still swing up,
but it should not drift downward when in place for welding.
4. To adjust the distance between the user’s face and ADF
(#5), clench wings on both sides
of the helmet (Fig. 2-4) until the
headband can move back and
forth freely, reposition the
headband at one of the 6 slots as
desired. This should be done one
side at a time and both sides
should be located at the same
position for proper auto-
darkening filter operation.
Fig. 2