![background image](http://html.mh-extra.com/html/pro-point/8354482/8354482_user-manual_1607376006.webp)
3/8" Heavy-Duty Air Ratchet
6
For technical questions call: 1-800-665-8685
8354482
V 1.0
AIR SOURCE
1. Disconnect air supply. Disconnect tools from air pressure
source when not in use, before cleaning, servicing or
changing a piece or accessory. After disconnecting,
discharge any residual air pressure.
2. Do not use tools if the trigger switch does not function
properly. Any tool that cannot be controlled with the ON/
OFF switch is dangerous and must be repaired.
3. Use proper size and type of air pressure line and fittings.
The recommended air line for a tool with a 1/4" inlet is
3/8" I.D.
4. Always verify prior to using a tool that the air source has
been adjusted to the rated air pressure or within the rated
air-pressure range. Over pressurizing a tool may cause
bursting, abnormal operation, breakage of the tool or
serious injury to persons. Use only clean, dry, regulated
compressed air at the rated range as marked on the tool.
5. Never use pure oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source for a tool. Such
gases are capable of causing an explosion and serious injury to persons. Do not use an air source besides an
air compressor to power this tool.
6. Always use an air regulator, an in-line filter and a moisture trap in your compressed air system. These
accessories will increase the tool's life and keeps the tool in good working condition.
7. Drain the air tank daily. Water in the air line will damage the tool.
8. Clean air inlet filter weekly.
9. Avoid using an unnecessarily long air hose. The longer the hose, the lower the pressure will be at the end of the
hose, to the point that it may not meet the minimum required for the tool. As well, a longer hose can become a
tripping hazard.
10. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all
connections are secure.
11. Always carry a tool by its handle, never carry the tool by the air hose.
12. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The hose
diameter should be 3/8" I.D.
13. Air tool CFM consumption ratings are based upon a 25% duty cycle. If you require continuous duty, a larger
compressor will be required (eg. 4.0 CFM tool at continuous duty requires 16.0 CFM to function
at maximum torque).
See the diagram above for recommended components of an air line.
Summary of Contents for 8354482
Page 1: ...User Manual 8354482 V 1 0 3 8 Heavy Duty Air Ratchet Please read this manual before use ...
Page 2: ......
Page 12: ......
Page 14: ......