18
Oil Tank and Fill
Depending on your selection of the various optional engine packages (i.e., oil injected outboard engines), your boat may
be equipped with a remote oil tank. If your engine package requires the installation of an oil tank, it will be mounted in the
bilge and can be accessed via the bilge hatches in the motor well. The oil fill will be installed port side of the transom.
Make sure that the oil tank is well stocked with the type of engine oil that is recommended for your engine. Refer to your
engine manual. It is imperative that the oil supply remains clean and uncontaminated by water or dirt. Check to make
sure the oil line is free from leaks, kinks and chafing. Some motors use a primer bulb to initiate oil flow. Air may
periodically enter the system and require purging. Refer to your engine manual for specific instructions.
If your optional engine package requires the installation of a remote oil tank, please refer to the owner’s manual provided
by the engine manufacturer for operational procedures and for information related to the care and maintenance of their
product. When in doubt, always defer to the engine manufacturer’s instructions and/or recommendations.
Fuel / Oil Leaks
The fuel tank is vented via the vented fuel fill fitting and the vent should be inspected for obstructions regularly. Verify that
all of the fuel hoses remain properly secured and located according to NMMA standards. Inspect all hose clamps and
fittings to ensure they are double clamped where needed and that there are no fuel leaks in any of the hoses. Also,
inspect the oil system, if applicable, and ensure that the oil tank and hoses remain properly connected and secured.
If you notice a fuel odor or see fuel in the bilge, there may be a leak somewhere in the fuel system. Correct any fuel leaks
before operating the vessel.
Caution: If at all possible
, any fuel tank and or fuel system repair should be handled by your Pro-Line
dealer’s service department or by another qualified professional.
Windows, Storage, Hatches and Latches
Windshield
The Plexiglas windshield assembly is molded to fit the console. DO NOT use commercially available glass cleaners
containing harsh chemicals such as ammonia or alcohol as this will permanently damage the windshield. Please refer to
the Service and Care section of this manual for cleaning recommendations.
Hatches and Latches
To open the hatches just lift the handle of the latch from the recessed area of the hatch, twist it and lift the hatch open.
Make sure that all hatches are closed and secured before you get underway.
In addition to the deck hatches, there are round access pies installed on the boat that provide access to components
below the deck.
Storage
Your boat has plenty of storage areas for your tackle and/or gear:
Rope locker storage at the bow
Center
console
Wet/dry storage compartment in the casting deck
storage box
Drink
holders
Rod Holder Storage – All SE Series boats include four vertical thru bolted rod holders installed on the console. Some SE
Series models may include an additional pair of gunwale mounted rod holders.
Hardware
Cleats
Cleats are installed to provide areas to permit you to tie off the boat at dockside, tie off to another boat that is anchored,
secure bumpers/fenders, and/or tie off the anchor when dropped to prevent the line from pulling on the windlass, etc. You
should never use the cleats for towing another boat or skier.
Summary of Contents for 2012 21 CC
Page 6: ...2...
