22
initiate oil flow. Air may periodically enter the system and require purging. Refer to your engine manual for
specific instructions.
Oil Tank and Fill
Depending on your selection of the various optional engine packages
(i.e., oil injected outboard engines), your boat may be equipped with
remote oil tanks. If your engine package requires the installation of an
oil tank, it will be mounted in the bilge as far aft as possible. The oil fill
will be installed on the outside of the transom above the motor well.
If your optional engine package requires the installation of remote oil tanks, please refer to the owner’s manual
provided by the engine manufacturer for operational procedures and for information related to the care and
maintenance of their product. When in doubt, always defer to the engine manufacturer’s instructions and/or
recommendations.
Fuel / Oil Leaks
The fuel tank is vented overboard and the vent should be inspected for obstructions regularly. Verify that all of
the fuel hoses remain properly secured and located according to NMMA standards. Inspect all hose clamps and
fittings to ensure they are double clamped where needed and that there are no fuel leaks in any of the hoses.
Also, inspect the oil system, if applicable, and ensure that the oil tank and hoses remain properly connected and
secured.
If you notice a fuel odor or see fuel in the bilge, there may be a leak somewhere in the fuel system. Correct any
fuel leaks before operating the vessel.
Caution: If at all possible
, any fuel tank and or fuel system repair should be handled by your
Pro-Line dealer’s service department or by another qualified service professional.
Sea Water System
Bilge Pumps
The boat is equipped with two (2) bilge pumps; separate switches on the switch panel operate each pump. The
locations of the two (2) bilge pumps and the labeling of the bilge pump switches are as follows:
Aft Bilge – This 1500 gph pump is located in the aft bilge and is accessible via the bilge hatch.
Fwd Bilge - This 500 gph pump is installed below the cabin floor and is accessible via the round
access pie that is installed next to the cabin step.
There are 2 steps in properly checking the bilge pumps. First, turn the on bilge pump at the instrument panel by
pressing the applicable bilge pump switch to the on or forward position. When the bilge pump switch is in the on
position, the switch light should be illuminated. To see if the bilge pump is operating, open the hatch over the
applicable bilge pump and listen to hear the bilge pump running.
Aft bilge pump and float
switch are located in the aft
bilge area
Forward bilge pump and
float switch are installed
beneath the cabin floor
Summary of Contents for 2010 26 Express
Page 2: ...ii ...
