The fresh water system hose is located just outside the transom door, behind a white
cap/cover. Pull open the cap and pull out the faucet/shower nozzle and hose. Press the
button on the nozzle to ensure proper operation (water spraying).
When you are finished, stow away the transom fresh water hose and cover the outlet with
the white rubber cap. If the fresh water system is not in going to be in use, return to the
switch panel and turn the fresh water switch to the off position. When you close the
faucet, the pump will run briefly. If the pump continues to run with the faucet closed,
check the system for leaks or have the pump tested.
Note: If you should hear a sucking sound, you may have a leak on the inlet side of the fresh
water tank. There are 2 hoses connected to the top of the tank. The larger diameter hose is the
water fill hose and the smaller diameter hose is the water vent hose. Inspect the hoses for leaks
and make certain that the hose connections are secure.
Fresh Water Tank and Fill
The 15-gallon capacity fresh water tank is installed in the
aft bilge and is accessible via the bilge hatch. The tank
can be filled via the stainless steel fresh water tank fill
located on the port gunwale at the transom. Twist the
cap to open the fitting. The cap is connected to the fitting
by a chain or cable so that it will not fall into the water
and/or get lost. Use a garden hose to fill the fresh water
tank through this fitting.
The vent for the tank is installed on the transom behind
the aft folding seat.
Important: Fill the tank with potable water only. Refilling the tank often will help to keep it a
source of clean fresh drinking water. Never fill the fresh water tank with anything other than fresh
water.
Fresh Water Faucet with Pull Out Shower at Transom
The fresh water system hose is located just outside the transom door, behind a white
cap/cover. Pull open the cap and pull out the faucet/shower nozzle and hose. Press the
button on the nozzle to ensure proper operation (water spraying). Depress the fresh
water switch located on the switch panel to the forward position to activate the fresh water
pump. Then, press the button on the faucet/nozzle to begin spraying. See the section
titled Fresh Water Pump for operating instructions before using the fresh water shower.
Sea Water System
Bilge Pumps
The boat is equipped with two (2) bilge pumps; separate switches on the switch panel operate each pump. The
locations of the two (2) bilge pumps and the labeling of the bilge pump switches are as follows:
•
Aft Bilge – This 1500 gph pump is located in the aft bilge and is accessible via the bilge hatch.
•
Fwd Bilge - This 500 gph pump is installed below the console and is accessible via round access
pie that is installed on the aft head wall.
20
There are 2 steps in properly checking the bilge pumps. First, turn the on bilge pump at the instrument panel by
pressing the applicable bilge pump switch to the on or forward position. When the bilge pump switch is in the on
position, the switch light should be illuminated. To see if the bilge pump is operating, open the hatch over the
applicable bilge pump and listen to hear the bilge pump running.
Summary of Contents for 2009 26 Super Sport
Page 2: ...ii...
