•
To operate the spreader lights - The spreader light switch operates in the same manor as the
courtesy light but only needs to be pressed in once to be turned on and once again to be turned
off.
Remote Spot Light (Optional)
The installation of the remote spot light requires the optional rigid T-top. The remote spot light is mounted to the
forward area of the rigid T-top. To operate the remote spot light, locate the remote spot light panel that is installed
on the console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located in the
center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the all around
toggle lever (on the left side of the panel) can be moved in an up, down, left or right position to rotate the light
assembly in the desired direction.
Remote Spot Light
Remote Spot Light Control Panel
Instrumentation
Horn - Electric
The horn is used to signal, warn or alert other boats or persons on shore. The horn switch is located on the
switch panel. The horn device is located just forward of the starboard bow light.
Depress the horn switch to the up or forward position to activate the horn, then release the horn switch to
deactivate the horn. Using different sequences of horn blasts indicates different and sometimes dangerous
situations to you or someone around you.
See the Safety Section in this manual for more information. Avoid any horn use without an appropriate purpose.
Additional information regarding audible warning signals should be covered in a safe boating course.
Compass
The compass is located on the dash on top of the console. To ensure
that the compass light is working properly, press the Nav. Lights switch in
the forward position to turn on the red LED light inside the compass.
When finished, turn the Nav. Lights switch back to the middle position.
Please refer to the owner’s manual provided by the manufacturer of the
compass for operational procedures and for information related to the
care and maintenance of their product. When in doubt, always defer to
the compass manufacturer’s instructions and/or recommendations.
Full Instrumentation / Gauges (Digital)
All gauges are installed on the console but the configuration and specific location of your gauges will vary
depending upon the selection of the various optional engine packages. If your engine package includes analog
gauges (i.e., Faria), the gauges will light up when the navigation lights are on. If your engine package includes
digital gauges provided by the engine manufacturer (i.e., Mercury SmartCraft, Honda, etc.), the gauges will light
up only when the engine is on.
18
Summary of Contents for 2009 26 Super Sport
Page 2: ...ii...
