10 Baitwell Pump - The baitwell pump is located in the bilge area and is plumbed to a seacock (ball
valve). This pump is also used for the raw water washdown. See the Sea Water section of this
manual for instructions on using the raw water washdown fitting.
For the pump to operate properly you need to make sure the seacock is in the open position.
The seacock is wide open when the yellow seacock lever is vertical. When the yellow seacock
lever is horizontal, the seacock is closed.
The underside of the seacock thru-hull is equipped with a scoop to allow the water to be picked
up even when the boat is on plane. When the boat is not in the water or the baitwell pump is not
going to be used for an extended period of time, the seacock valve should be in the closed
position.
To activate the pump, depress the switch to the up or forward position. To turn the pump off
after the baitwell tub is full, depress switch to the down or aft position.
11 Fish Box Pump - This switch directs power to the fish box macerator pump, which allows you to
drain the water and debris from the aft fish boxes. The macerator pump allows you to pump all
the water, ice and scales out of the aft fish boxes by grinding up the debris and discharging it
overboard. The forward fish boxes are not connected to this system and their contents will
gravity drain via thru hulls on the side of the boat.
To activate the pump, depress the switch to the up or forward position. This action will drain the
fish boxes of water and/or debris and transport it to the macerator pump to be macerated and/or
discharged overboard. When not in use, the switch should be left in the off position.
12 Fresh Water (Optional) – The fresh water switch provides power to the fresh water pump.
Depress the fresh water switch to the forward position to activate the fresh water pump. The
fresh water faucet/nozzle is installed behind a white cap located just out side the transom door.
Press the button on the handle to activate the faucet/nozzle. If the fresh water system is not
going to be in use, stow away the hose and move the switch to the aft or down position to turn
the pump off.
13, 14 Accessory - These two 5 Amps accessory switches can be used for additional dealer installed
accessories. Please check the amp rating of any new component and/or additional accessory
before installation.
Circuit Breakers
Circuit breakers and/or fuses protect the wiring. In the event a device stops working, check to see if the
circuit breaker is tripped or if the fuse is blown. Breakers are installed in the following locations:
•
The main breaker is located on the transom behind the bilge hatch.
•
Additional breakers and/or fuses for the aft bilge, stereo and optional trim tabs are
located next to the main breaker.
•
Additional breaker switches are also located on the switch panel below the individual
switches.
A tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the on position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
18
