Controls
Controls and engine systems vary greatly from one engine manufacturer to another. Please read your
engine owner’s manual carefully.
Note: If your engine package was
not factory installed
, some components that are
normally standard installations may not be included.
Throttle & Shift Controls
Ignition – Binnacle, Forward, Neutral and Reverse Gear Operation
The binnacle on the 23 Sport is located at the console forward of the helm seat. To ensure that the
binnacle is working properly, shift the binnacle forward to put the engine in forward gear. Make sure the
engine shifts smoothly into idle with no grinding of the gears. Bring the binnacle back into neutral and
repeat the same process while going into reverse. Again, ensure that there are no gears grinding. It is
important to check the binnacle at wide-open throttle (WOT) to ensure the binnacle is not stiff and
operates smoothly while going into the WOT position.
Actual binnacle will vary depending upon the engine package that was selected.
Key Switch Alarm
The key switch alarm is located in the binnacle and sounds when the ignition key is turned on. The key
switch alarm is actually a warning alarm that goes off when any overheating problems may occur with the
engine. To check the key switch alarm, turn the ignition key to the right but do not start the engine. The
alarm will sound ensuring that the engine warning alarm is working properly. When finished, turn the key
off.
Lanyard Stop Switch
To ensure the lanyard stop switch (also called the emergency stop feature) on the engine works properly,
first turn on the ignition key and start up the engine. While the engine is running, locate the lanyard stop
switch. The lanyard stop switch is installed in close proximity to the binnacle or the ignition key. While
the engine is running in the neutral position, pull the lanyard stop switch downward until the plastic
element at the end of the lanyard pulls the stop switch pin into the off position. This process will
automatically stop the engine and will ensure that the emergency lanyard stop switch is working properly.
11
