5
1. Make sure that there are Stabilizer Endcaps (27) on
the ends of both Stabilizers (30).
Hold one of the Stabilizers (30) against the saddle on
the front of the Base (1). Make sure that the Stabilizer
is turned so the square holes are facing away from
the Base. Attach the Stabilizer with two 3/8Ó Carriage
Bolts (28) and two 3/8Ó Nylon Locknuts (29).
2. Hold the other Stabilizer (30) against the saddle on
the rear of the Base (1). Make sure that the Stabilizer
is turned so the square holes are facing away from
the Base. Attach the Stabilizer with two 3/8Ó Carriage
Bolts (28) and two 3/8Ó Nylon Locknuts (29).
ASSEMBLY
Assembly requires two persons.
Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials.
Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver , two adjustable wrenches , and a
rubber mallet .
2
1
27
1
1
30
30
29
29
28
28
27
3
4. Refer to the inset drawing. Remove the 3/8Ó Bolt (50)
and the 3/8Ó Nylon Locknut (29) from the lower end of
each Upper Body Arm (10, 11).
The Bolts and Nylon
Locknuts will be used in assembly step 4.
Apply a thin film of grease to both to the Upper Body
Arm Housing (63) on each Upper Body Arm (10, 11)
at the indicated locations.
Hold the lower end of the Left Upper Body Arm (10)
inside the bracket on the Upright (3). Insert the Long
Carriage Bolt (66) into the bracket and through the
Left Upper Body Arm.
Hold the Right Upper Body Arm (11) inside the brack-
et on the Upright (3). Insert the Long Carriage Bolt
(66) through the Right Upper Body Arm. Make sure
that the head of the Carriage Bolt is in the square
hole in the bracket. Slide the 3/8Ó Star Washer (68)
onto the Long Carriage Bolt. Tighten the Arm
Resistance Knob (69) onto the Long Carriage Bolt.
11
Grease
Grease
69
Bracket
68
3
66
63
63
10
50
10
29
63
