21
MAINTENANCE
Inspect and tighten all parts of the dual trainer
regularly. Replace any worn parts immediately.
To clean the dual trainer, use a damp cloth and a small
amount of mild detergent.
IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries;
see assembly step 12 on page 12 for replacement
instructions.
HOW TO GREASE THE ROLLERS
See EXPLODED DRAWING A near the end of this
manual. If the Seat Rollers (92) squeak when moving
on the Rail (5), apply a small amount of the included
PTFE grease to a paper towel. Spread a thin layer
of grease evenly along the Rail. Then, wipe off any
excess grease.
HOW TO ADJUST THE LEFT-SIDE REED SWITCH
If the console does not display correct feedback
when the dual trainer is set up in the Recumbent
mode,
the left-side reed switch should be adjusted.
To adjust the left-side reed switch, you must first
remove the left pedal and the left disc as described
below.
See EXPLODED DRAWING B on page 27. Using an
adjustable wrench, turn the Left Pedal (10)
clockwise
and remove it. Then, using a flat screwdriver, gently pry
off the left Disc (23).
Locate the left-side Reed Switch (22). Turn the Left
Crank Arm (85) until a Magnet (109) is aligned with
the Reed Switch. Loosen, but do not remove, the #8 x
12mm Flange Screw (28).
Slide the left-side Reed Switch (22) slightly closer to or
away from the Magnet (109), and then retighten the #8
x 12mm Flange Screw (28). Turn the Left Crank Arm
(85) for a moment.
Repeat these actions until the console displays correct
feedback. When the left-side reed switch is correctly
adjusted, reattach the left disc and the left pedal.
MAINTENANCE AND TROUBLESHOOTING
22
109
85
28