6
Attaching to a place other than the
Display Unit
When attaching this product to a panel other
than the main body of the display unit, attach it
at the two points identified in the diagram below.
Drill holes suitable for screws as shown in the
diagram. For attachment information, refer to
"Attaching directly to the Display Unit".
NOTE:
This product is not approved as an
enclosure. When building this product into an
end-use product, be sure to use an enclosure
that satisfies standards as the end-use product’s
overall enclosure.
Cleaning this product
When this product gets dirty, soak a soft cloth in
water with a neutral detergent, wring the cloth
tightly and wipe this product.
CE Marking
• This product is a CE marked, EMC compliant
product. This product also conforms to
EN61000-6-4, EN61000-6-2 directives.
KC Marking
사용자안내문
The following message is for UL Hazardous
Locations.
NOTICE
EQUIPMENT DAMAGE
•
Power off this product before cleaning it.
•
Do not use paint thinner, organic solvents, or
a strong acid compound to clean the unit.
Failure to follow these instructions can result
in equipment damage.
I
9
0.35
0.7
0.03
2.7
0.11
I
3.3
0.13
M3 screw
6.5
0.26
75
2.95
2 x M3
mm
in
4
0.16
A급 기기
( 업무용
방송통신
기자재 )
이 기기는 업무용 (A 급 ) 전자파적
합기기로서 판매자 또는 사용자는
이 점을 주의하시기 바라며 , 가정
외의 지역에서 사용하는 것을 목적
으로 합니다 .
DANGER
RISQUE D’EXPLOSION
•
Le remplacement de n’importe quel
composant peut nuire à la conformité à la
Classe I, Division 2.
•
Avant de déconnecter l’équipement, couper
le courant ou s’assurer que l’emplacement
est désigné non dangereux.
Le non-respect de ces instructions provoquera
la mort ou des blessures graves.
Inquiry
If you experience difficulties or have
questions about this product, please contact
us any time.
You can access our support site whenever
you need help with a solution.
http://www.pro-face.com/trans/en/manual/
1001.html
Please be aware that Digital Electronics
Corporation shall not be held liable by the
user for any damages, losses, or third-party
claims arising from the use of this product.
Note
