5
1) Using a Phillips screwdriver, attach one screw
(M3) to the display unit’s rear side. Use a torque
of 0.5 N•m (4.4 lb-in).
2) Attach this product to the display unit.
3) Slide this product in the direction of the arrow
so it is hooked by the screw from step 1.
4) Fix this product in place with another screw.
Use a torque of 0.5 N•m (4.4 lb-in).
NOTE:
• When attaching this product to the display
unit, be careful with the attachment position.
• Attach this product to a stable surface. Do not
leave it hanging by its cord.
• Be careful with wire placement. If this
product's cable overlaps with other cables,
excessive noise could cause a malfunction.
• Install this product in an enclosure with
mechanical rigidity.
• This product is not designed for outdoor use.
UL certification obtained is for indoor use
only.
• Make sure this product is placed inside the
edges of the display unit.
Correct
Incorrect
• Do not place this product over the slits.
Correct
Incorrect
Rear face of Display
Rear face of Display
Rear face of Display
Rear face of Display
