Pro-face FP5000 Series, User Manual

Page: 63 / 95

FP5000 Series User Manual
63
*2 Items are manufactured by Phoenix Contact.
Power Supply Connector Specifications: Spring Clamp Terminal Blocks
This product comes with the right-angle-type power connector.
NOTE:

You can also use a straight-type power connector.

Right-angle type: PFXZCBCNDC2 by Pro-face.
Straight type: PFXZCBCNDC1 by Pro-face.
How to connect the DC Power Cord
NOTE: Do not solder the wire directly to the power crimp pin.
Right-angle type Straight type
Connection Wire
+ 12...24 Vdc
- 0 Vdc
FG Grounded terminal connected to the panel chassis.
Step Action
1 Confirm the power cord is not connected to the power supply.
2 Check the rated voltage and remove the “DC24V” sticker on the DC power
supply connector.
3 Connect each wire from the power cable to a pin terminal.
4 Push the opening button with a small and flat screwdriver to open the desired
pin hole.
5 Insert each power cord wire into its corresponding holder. Release the opening
button to clamp the wire in place.
When using stranded wire, do not short with neighboring wires.
6 After inserting all three power cord wires, insert the DC power supply connector
into the power connector on this product.