Pro-face AGP-3300 Series, User Manual

Page: 26 / 89

Chapter 2 Specifications
2-3
2.1.3 Structural
*1 The front face of the AGP unit, installed in a solid panel, has been tested using conditions equivalent to
the standards shown in the specification. Even though the AGP unit’s level of resistance is equivalent to
these standards, oils that should have no effect on the AGP can possibly harm the unit. This can occur in
areas where either vaporized oils are present, or where low viscosity cutting oils are allowed to adhere to
the unit for long periods of time. If the AGP’s front face protection sheet becomes peeled off, these con-
ditions can lead to the ingress of oil into the AGP and separate protection measures are suggested. Also,
if non-approved oils are present, it may cause deformation or corrosion of the front panel’s plastic cover.
Therefore, prior to installing the AGP be sure to confirm the type of conditions that will be present in the
AGP’s operating environment. If the installation gasket is used for a long period of time, or if the unit
and its gasket are removed from the panel, the original level of the protection cannot be guaranteed. To
maintain the original protection level, be sure to replace the installation gasket regularly.
Installation
Grounding
Functional grounding: Grounding resistance of 100
Ω
, 2mm
2
or
thicker wire, or your country’s applicable standard. (Same for
FG and SG terminals)
Structure
*1
Rating: Equivalent to IP65f NEMA #250 TYPE 4X/12
(Front face of installed unit)
Cooling
Method
Natural air circulation
Weight 1.0 kg [2.20 lb] max. (unit only)
External
Dimensions
W167.5mm [6.60 in] x H135mm [5.32 in] x D59.5mm [2.34 in]