5
Use charger for charging a LEAD
-
ACID (lead acid, sealed lead acid, gel cell and AGM) battery
only. It is not intended to supply power to a low voltage electrical system other than in a
starter
-
motor application. Do not use battery charger for charging dry
-
cell batteries that are
commonly used with home
appliances. These batteries may burst, causing personal injury and damage to property.
Utiliser le chargeur pour charger une batterie au plomb uniquement. Ce chargeur n
’
est pas concu pour alimenter
un réseau électrique très basse tension ni pour charger des piles sèches. Le fait d
’
utiliser le charger des piles sèch-
espourait entrainer l
’
éclatement des piles et causer des blessures ou des dommages.
DO NOT attempt to attach a charger to a battery pack if the output of the charger does not match the battery
pack voltage. Example: Model i
-
3625 is a 36 volt output charger and is only usable on 36 volt battery systems.
NEVER connect to just one battery (ie. 6V) in the pack. Damage can occur.
Be extra cautious to reduce risk of dropping a metal tool onto battery. It might cause a spark or short
-
circuit a
battery or other electrical part, possibly resulting in an explosion. If damaged, contact PCS
(
615.471.5300
).
NEVER charge a frozen battery.
Ne jamais charger une batterie gelée.
Assure that the area around your charger and batteries is properly ventilated. Connect your extension cord, with
no AC Power present, to the battery charger and proceed to plug your extension cord into a
120VAC GFCI protected (Ground Fault Circuit Interrupt) outlet.
Risk of electrical shock! Do not touch uninsulated parts of the battery charger output
connector, battery connector, or battery terminals.
Once you plug in your PCS battery charging system, the charge cycle will begin automatically.
State of charge will be displayed by illumination of the Light Emitting Diodes (LEDS) on the
battery status indicator located on the front of the unit.
DO NOT connect or disconnect the DC output electrical cord to or from the battery
receptacle when the charger is on. Arcing and / or burning of the plug and receptacle could result and could
cause the batteries to explode. If the charger must be stopped, first
disconnect the AC power supply cord from its outlet, then disconnect the charger DC output
plug from the battery receptacle.
We recommend that you leave your system plugged in. This will reduce sulfation on the lead
plates of the batteries and allow your PCS charging system to keep your batteries fully main-
tained and ready to perform at their best.
Study all battery manufacturers
’
specific precautions such as removing or not removing cell caps while charg-
ing and recommended rates of charge.
Prendre connaissance des measures de précaution spécifiés par le fabricant de la batterie, p. ex., vérifier s
’
il faut
enlever les bouchons des cellules lors du chargement de la batterie, et les taux de chargement recommandés.
