14
TROUBLE SHOOTING
1.No picture
a. The connection could be not correct, please contrast the connection with illustration.
b. Check the power plug whether it is firmly connected and the supplied voltage
meets the adapter rating.
c. Make sure that the selected mode is the same as input signal, and then perform
AUTO SCAN again.
( For example : under “AIR TV “ mode, the F connector has to be connected with
UHF/ VHF antenna. Under “CATV“ mode, the F connector has to be connected
to CATV system.)
2.
No sound
The connection could be not correct, please contrast the connection with illustration.
3. TV BOX has no response while using remote controller
a. Make sure that you are pointing to the IR sensor window of TV BOX within 6 M,
and +/- 15 degrees.
b. Please check the batteries and replace with new one if necessary.
*****************************************************************************************************
The standard of VGA signal output from this unit TV BOX is identical to
general PC VGA display card, so the use of this unit will not violate the
warranty of LCD or CRT monitor.
*****************************************************************************************************
USER INFORMATION
This equipment has been tested and found to comply with the limits for a Class B Digital
Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction may cause harmful interference to
radio communication,. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
--Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
--
Consult the dealer or an experienced radio/TV technician for help
