NOTE
Normally it is not necessary to release the locking ring.
u)
Accept a Reset with OK. Check that the display value is / - 0.500mm,
press OK to to set the instrument to ZERO (0.000mm).
Continue with this procedure until all cylinders are completed.
v)
When the display reads ”MEASURING DONE”, press OK.
NOTE
Before accepting ”MEASURING DONE” you wish to re-measure a cylinder,
return to that cylinder number using < / > buttons, press OK.
The display will read REMEASURE CYLINDER ?
Press OK and repeat the measuring sequence.
2:6 PRINT DOCUMENTS
When the measurement data have been transferred to the PC program it is possible to
make printouts. See separate “Program Manual for PC”.
2:7 STORE DOCUMENTS
All measuring data and information is stored when the OK button is pressed.
This data is fully retained, also when batteries are low or empty.
Memory capacity of the DI-5C allows 45 complete documents to be stored.
Each cylinder measured will display the value in brackets [ ] indicating the position has
already been measured. Should you want to return to a particular cylinder, select
cylinder number and press OK, the display will ask if you wish to re-measure the position,
if yes, press OK, this will delete the previous data. New measurements can be taken as
described in section 2:5.
2:8 FIND STORED DOCUMENTS
To find stored documents you should follow the procedure below;
•
Start the instrument by pressing OK, accept date/time with OK
•
The display will ask NEW DOCUMENT?
•
Pressing the right > arrow the display will move to FIND STORED DOCUMENT,
press OK
•
The display will now ask you to choose DOCUMENT NR.
•
Using the right > arrow key, you move to the required document, then
press OK.
•
The display now shows READ DOC (see section 2:10), continue to use the
left < arrow key, the next display will show EDIT DOC (see section 2:9),
next, RETURN TO BASE, next FIND OTHER DOCUMENTS, and DELETE DOC
(see section 2:11).
2:9 EDIT DOCUMENTS
This menu allows you to recover and view previous measurements, or continue to
measure incomplete data. Follow section 2:8 above until EDIT DOC is displayed,
press OK, then proceed as described in section 2:5.i
