Design Guide
Page 7
©2015 Prinsco, Inc | 800.992.1725 |
05/15
Figure 4 - Chamber Joint Assembly
2.5
End Caps
HydroStor End Caps are designed to fit over the end of the chamber in order to terminate the
chamber row. (Figure 3) The end caps are molded with handles to allow easy use and
manipulation in the field. Each endcap must be attached to the chamber by use of three (3) self-
tapping screws at the indicated locations. The chambers are required to be placed at the end of
each row in order to seal the chamber from the aggregate surrounding it. This requires two end
caps per row to be ordered with each chamber system. Endcaps for the HS75 will accept up to 18”
pipe for inlet and outlet to the row. Endcaps for the HS180 accept up to 24” pipes. Illustrations of
HydroStor HS180 and HS75 end caps are shown in Figures 1 and 2 above.
Summary of Contents for HydroStor HS180
Page 1: ...DESIGN GUIDE...
Page 35: ......
