3. View DTCs and their definitions on screen.
4. If more than one DTC is found, use
UP/DOWN
button, as necessary. If no codes are
detected, a
No codes are stored in the module
message displays on the screen. If a code
appears with no definition refer to the vehicles service manual. Additionally the internet has the
code definitions and possible solutions.
5. Press
EXIT
button to return to previous menu.
Erase Codes
CAUTION:
Do not erase the codes before the system has been checked completely by a
technician.
This function is performed with Key on Engine off (KOEO). Do not start the engine.
1. To erase codes select #2 on the menu, you’ll be prompted to confirm. Use the
UP/DOWN
button to select your choice. Select NO and press
ENTER
will cancel the command.
2. Press
ENTER
button to erase. If the codes are cleared successfully, an
Erase done
message shows up.
If the codes are not cleared, then an
Erase Failure Turn Key on with Engine off
message
displays. Some codes cannot be erased and must be serviced by the dealer.
Deactivate Brake
WARNING:
Deactivate the SBC system before carrying out any maintenance/service work on
the brakes such as changing of pads, discs and fluids.
Use proper tools to avoid the risk of body injuries or damage to the brake system. Make sure
the vehicle is properly blocked with wheel chocks before deactivation of the system.
1. To deactivate the EPB functions, use
UP/DOWN
button to select Deactivate Brake from
menu and press
ENTER
button.
1) Read Codes
2) Erase Codes
>3) Deactivate Brake
4) Activate Brake
2). Wait a few minutes while the tool is deactivating the system. When the brakes are
deactivated successfully, a
Deactivation done
message is displayed. Press any key to
continue.
If the tool fails to open the brake pads, a
Deactivation Failed! Please try again
message is
displayed.
This process may not be supported with the W3000 EPB Tool.
Verify that the ignition is ON; Key On Engine Off
Diagnose SBC On Mercedes Cont.
Check if the brake tool’s OBD II connector is securely connected to the vehicle’s DLC;
Check that the park brake is released;
Turn the ignition off and turn it back on 10 seconds later;
Repeat the process.
3. Press any key or wait a few seconds to return to previous menu.
Activate Brake
WARNING:
The SBC system must be activated after finishing service work on the brakes.
