4. Change the pads.
5. Activate the brakes as instructed earlier.
6. Use
UP/DOWN
button to select Adaptation from Select Function menu and press
ENTER
button.
>5) Adaptation
6) Function Test
7. Wait a few seconds until following screen shows:
03mm
DOWN
Button or
UP
button = Change
N
= Exit
Y
= Confirm
8. Use
UP/DOWN
button to enter new pad thickness, and press
ENTER
button to confirm.
If you want to quit the setting, press EXIT button and a
“Command Cancelled!” message
comes up.
9. An
Adaptation done
message comes up on screen indicating the setting is performed
successfully. If the setting is not carried out successfully, an
Adaptation Failed
message
shows. Repeat steps above to try again.
10. Wait a few seconds or press any key to return.
11. Turn the ignition off.
Function Test (Audi)
This confirms the brake calipers are functioning properly after being serviced.
1. Use UP/DOWN button to select Adaptation from Select Function menu and press ENTER
button.
5) Adaptation
>6) Function Test
Diagnose EPB
On Other Audi’S Models
Reading Codes
1. Use
UP/DOWN
button to select Other Audi from AUDI Menu and press
ENTER
button to
confirm.
1) Audi A8
>2) Other Audi
2. Use
UP/DOWN
button to select Read Codes from Select Function menu and press ENTER
button to confirm.
>1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
3. View DTCs and their definitions on screen.
4. If more than one DTC is found, use
UP/DOWN
button, as necessary.
If no codes are detected, a “No codes are stored in the module!” message displays on the
screen. If a code appears with no definition refer to the vehicles service manual. Additionally
the internet has the code definitions and possible solutions.
5. Press EXIT button to return to previous menu.
