Erase Codes (Other Audi)
CAUTION:
Do not erase the codes before the system has been checked completely by a
technician.
This function is performed with Key on Engine off (KOEO). Do not start the engine.
1. To erase codes select #2 on the menu, you’ll be prompted to confirm. Use the up/down
button to select your choice. Select NO and press
ENTER
will cancel the command.
2. Press
ENTER
button to erase. If the codes are cleared successfully, an Erase done
message shows up.
If the codes are not cleared, then an
Erase Failure Turn Key on with Engine off
message
displays. Some codes cannot be erased and must be serviced by the dealer.
Deactivate Brake (Other Audi)
WARNING:
The EPB system must be deactivated before any service work on the brake
system can be done. Including opening/closing the calipers for changing pads, discs or the
calipers.
Use proper tools to avoid the risk of body injuries or damage to the brake system. Make sure
the vehicle is properly blocked with wheel chocks before deactivation of the system.
1. To deactivate the EPB functions, use
UP/DOWN
button to select Deactivate Brake from
menu and press
ENTER
button.
1) Read Codes
Diagnose EPB
On Other Audi’S Models Cont.
2) Erase Codes
>3) Deactivate Brake
4) Activate Brake
2. Use
UP/DOWN
button to select the purpose of deactivating the brake.
>1) For Pad Change
2) For Repair
Select the purpose of deactivation properly.
For Pad Change is used to open the brake calipers completely for changing of worn pads.
For Repairs is used for repairs other that pad change. The Calipers will not open wide enough
to install new pads. Only enough to get the existing pads out for other repairs.
3. Wait while the tool is deactivating the brakes, you may hear the calipers opening. When they
are deactivated successfully, a
Deactivation done
message comes up. Press any key to
continue.
If the tool fails to open the brake pads, a
Deactivation Failed! Please try again
message
comes up.
Verify that the ignition is ON; Key On Engine Off
Check if the brake tool’s OBD II connector is securely connected to the vehicle’s DLC;
Check that the park brake is released;
Turn the ignition off and turn it back on 10s later;
Repeat the process.
4. Press any key or wait a few seconds to return to previous menu.
Activate Brake (Other Audi)
