2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER
11
For technical questions call: 1-800-665-8685
8384281
V 2.0
CONNECTING A GARDEN HOSE TO
THE PRESSURE WASHER
1. Run water through the hose for 30 to 60 seconds to flush any
debris from the hose.
2. Inspect the inlet screen and remove any debris.
3. Connect the garden hose to the water inlet and tighten by hand.
There must be a minimum of 10 ft of unrestricted hose
between the pressure washer and the faucet or shut off valve.
4. Turn on the water.
5. Purge the systems’ pump of air by releasing the safety and
squeezing the trigger of the spray gun.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
1. Attach the end of the high pressure hose to the high pressure
outlet on the pump.
2. Follow the same procedure with the opposite end to attach the
high pressure hose to the spray wand.
3. Pull back on the quick connect collar to attach the spray tips.
4. Once the nozzle is inserted, press and hold it while you release
the collar. Releasing the collar should lock the tip in place.
WARNING! An unlocked tip may cause injury or damage. Verify that
the tip is locked by tugging on the tip before attempting to spray.
OPERATION
PRE-OPERATION CHECK LIST
• Read and understand this operator manual in its entirety before operating this pressure washer.
• Check the oil level and add oil to the proper level if low.
• Check the fuel level and add fuel if needed.
• Check the connections of the handle and all hoses to make sure they are secure.
• Check all hoses for kinks and damage.
• Check the flow of the water supply and make sure it is adequate.
WARNING! Do not run the pressure washer with a damaged hose. Do not run the pressure washer without first
connecting and turning on the water supply or damage to the pressure washer could result. Failure to follow
these instructions will void the product warranty.
FIG. 6
FIG. 7
Summary of Contents for 2.3 GPM @ 2
Page 2: ......
