2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER
12
For technical questions call: 1-800-665-8685
8384281
V 2.0
STARTING THE PRESSURE WASHER
WARNING! Do not run the pump without connecting to the water
supply and turning the water on or damage to the pressure washer
could result. Failure to follow these instructions will void the
product warranty.
WARNING! Do not attempt to assembly or operate this pressure
washer until you have read and understood the entire manual.
If you have any problems assembling or operating this unit,
contact your dealer or a qualified service centre.
1. Place the pressure washer on a level surface.
2. Turn on the water
3. Purge the system’s pump of air by releasing the safety and
squeezing the trigger of the spray gun.
4. Attach the wand / lance to the spray gun.
5. Turn the fuel valve to the ON position.
6. Turn the on / off switch to the ON position.
7. Slide the choke lever to the “Choke” position.
8. Pull the recoil handle (starter cord) slowly until resistance is
felt, then pull rapidly.
9. Let the engine run for several seconds and then gradually slide
the choke lever to the RUN position as the engine warms up
until the choke is fully slid to the RUN position.
STOPPING THE PRESSURE WASHER
1. Turn the on / off switch to the OFF position.
2. Turn the fuel valve to the OFF position.
3. Turn off the water and squeeze the trigger handle to release the water pressure.
FIG. 8
FIG. 9
Summary of Contents for 2.3 GPM @ 2
Page 2: ......
