VVR - MANUAL
5 | VVR– Manual | AntecControls.com
LMX (Single Valve)
The single venturi valve retrofit for LMX ships with several different components. The
components are outlined in this section for a single venturi valve with an LMX.
Component
Quantity
Description
LMX
1
Single LMX controller.
LMX Mounting
Bracket
1
Bracket used to mount the LMX to the controls
enclosure.
Potentiometer
Cable
1
Cable used to connect the FHC to the
potentiometer.
Green Pressure
Tubing
1
The low pressure tubing comes with 29” of length
and a connector tee.
Red Pressure
Tubing
1
The high pressure tubing comes with 18” of length
and a connector tee.
Terminal Block
1
3-pole terminal block that will be used to wire the
potentiometer cable to the existing potentiometer
Actuator
1
The actuator comes mounted on the mounting
bracket and shaft.
Mounting Bracket
with Linkages
1
The single venturi valve mounting bracket and
linkages comes pre-assembled. The unit just needs
to be positioned and fastened with 4 self-tapping
screws.
NOTE:
Unit is shipped with label on the bottom of the LMX to indicate which valve it should
be installed on. The image on the left hand side shows the bottom of a LMX with the
corresponding identification label.
CAUTION
When units are shipped mounted in an
enclosure, the label will be shown on the
enclosure.