541-531revD-EN
3
Printed in USA 10/10 © 2010
Product Holding Bin
DHB-BK41/43
Operation
Turn power On/Off switch to ON position.
1
Load pan covers (if used) onto pan racks
and insert racks into the unit.
Power On/Off Switch
Allow 30 minutes for heaters
to reach operating
temperature. The
Temperature Display will
show temperature as unit
warms up to the operating
temperature.
LED Timing Status
3
LED Timers
RED
(steady) = Ready for product
RED
(flashing) = Discard product
GREEN
(steady) = Oldest product, use first
GREEN
(flashing) = Cook more product
YELLOW
(steady) = Newer product, use green first
YELLOW
(flashing) = Cook more product
When any of the timer LEDs flash, cook more product or remove
and discard product as indicated.
5
GREEN
(flashing) = Cook
more product
YELLOW
(flashing) = Cook
more product
RED
(flashing) = Discard
product
Hot surfaces.
WARNING
Press all PAN buttons.
2
The PAN displays will show the
assigned product name.
If no product is assigned, the
display will be dim and show “- - - -”.
Pressing the PAN button will not
activate the timer if “- - - -” is
displayed. Pressing PAN button
when product name is displayed will
start timing cycle.
BKFT (Breakfast) or REG
(Regular Menu) will be lit
depending on pre-
programmed menu.
When LED is steady RED, load product and press the PAN
button.
4
If no other pan is active for a
product, the LED for the first
pan loaded will turn from RED
to GREEN.
The LED for the 2nd pan (3rd
pan, etc.) loaded will turn from
RED to YELLOW.
An LED timer can be stopped
(cancelled) at any time by
pressing and releasing the
corresponding PAN button.
If only one pan is active for a product, the LED will turn
from RED to GREEN.
MENU
ENTER
TRANSFER
Product, along with any remaining time, can be transferred from
one cavity to another as follows:
6
A. Press and release the
TRANSFER button on the timer
bar of the product to be moved.
Displays for all pans available
for transfer will be brightly lit. All
others will be dimly lit.
C. Press and release the
TRANSFER button on the bar
where the product will be
moved. All available pan
locations on the bar will be
brightly lit.
B. Press and release the PAN
button of the product to be
moved.
D. Press and release the PAN
button for the new location. The
new location will finish timing
the product. When the
transferred pan time expires,
the location will revert back to
the original menu settings.
NOTE: If product transfer is not completed within a pre-programmed
transfer time, the transfer will be cancelled. See your Manager.
