Steamer 625-50
2
revA
Printed in USA
0
910
© 200
3
4
Steamer
625-
A
Programming Product Name & Water Cycle
Filet
Large
PROD1
PROD2
PROD3
PROD4
PROD5
PROD6
PROD7
PROD8
PROD9
PROD10
PROD11
PROD12
– – – –
ON 1.1
FILET
1
A. Press and hold the LOGO button and a PRODUCT button for
approximately 6 seconds. The display will show the current
assigned product for the button pressed.
NOTE: A decimal point will appear and flash on the right side of
the display to indicate Programming mode.
The Program button menus can be changed to any of the
following menu items.
PROD1 thru PROD12 can be selected to program additional
product names.
“– – – –” can be used when no product name selection is desired.
6
A. Press the UP or DOWN Arrow buttons to change the valve
ON time.
B. Press the
Steamer
LOGO button to store the new valve
ON time.
NOTE: Pressing the Product 3 button at any time exits the
Program mode without storing the change.
ON 1.1
ON
1.1
5
The display now shows the product’s water valve ON time in
seconds.
OFF 2.5
7
The display now shows the product’s water valve OFF time
in seconds.
PROD 1
PROD 1
2
3
B. Press the UP or DOWN Arrow button to scroll through the
product selections.
C. Press the
Steamer
LOGO button to store the new product
name.
To enter custom product names, proceed to step 3.
NOTE: Pressing the Product 3 button at any time exits the
Program mode without storing the change.
Press and hold the Prince Castle LOGO button first, then press
and hold the
Steamer Logo
button for 6 seconds.
The display will show the product name with the left-most
character display or decimal point flashing.
NOTE: Must be in Programming mode.
CROD 1
4
A. Press the UP or DOWN Arrow buttons to change the
left-most character.
B. Press the Product 1 or Product 4 button to move the cursor
to the next character.
C. Repeat steps A and B for each character.
D. Press the
Steamer
LOGO button to store the new
product name.
NOTE: Pressing the Product 3 button at any time exits the
Program mode without storing the change.
CHKN 1
PROD 1
