PRIME DESIGN, A SAFE FLEET BRAND
▪
Address: 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118
▪
Phone: 651-552-8554
▪
Toll Free: 1.8.PRIME.RACK
▪
Fax: 651-552-1799
▪
Email: [email protected]
▪
Website: www.primedesign.net
TM & © 2018 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6764268, 6971563, 2364879, 8857689, 8511525, 8991889, 2271515, 2364897, 9506292, 9481313, 9481314, 9796340, 6202807, 6427889, 9415726 AND OTHER PATENTS PENDING
5
Z Plate Cam
Flat Washer
M8 Locknut
Z Plate
M8 x 45MM
Even
Even
Even
Even
Same as Front
Center
Rear
Front
The end of the Rear
Drive Shaft is Flush to
the Vehicle’s Bumper
Do not tighten
VRR3-GM31G-ST B
ASE
ASSEMBL
Y INSTR
UCTIONS–CROSSB
AR MOUNTINGS
1.5
Leave all indicated screws on all the
Mounting Brackets loose at this time.
1.4
Apply Anti-Seize to all M8 x 65MM Carriage bolts, then
install the Z Plates using the hardware shown. Do not
tighten screws until Step 1.8
CROSSBAR ADJUSTMENT
1.3
Using two or more people, lift and position
the Ladder Rack onto the vehicle.
1.6
Position all Crossbars onto the
Mounting Brackets as shown below.
1.7
Torque all of these
Screws to 90 in-lbs
Summary of Contents for VRR3-GM31G-ST
Page 1: ......
