Carefully lay fully assembled Ladder
Stand front ladder side down so that the
tree attachment side is facing upward.
Attach the hooked side of Truss Cable
without the tension adjuster to the
eyelet hole welded on the bottom front
of the foot platform assembly (as shown
left) .
NOTE:
Top hook should ALWAYS face
inward, away from the front of ladder
(as shown left).
Attach the hooked side of Truss Cable with the tension
adjuster to the eyelet hole welded on the bottom rung of
Bottom Ladder Section .
NOTE:
It may be necessary to pre-tension the cable by
tightening the tension adjuster several turns clockwise
before placing it on the Truss Bar .
Stand in the middle of the ladder, pull up on the Truss Cable and place it
onto the Y-shaped end of the Truss Bar . Tighten the cable so that there
is enough tension to create a slight bow in the Ladder Structure (as shown above).
NOTE:
It should take minimal effort to lift the Truss Cable onto the Truss Bar, if
truss cable is not easy to lift, STOP immediately, loosen the truss adjuster and
repeat the process.
1
3
1
2
3
2
Truss Assembly Instructions
NOTE:
Drawings are for illustration purposes only and may not depict actual product.
E
E
Model: PVLS-316
17’ Single Vantage Deluxe Ladder Stand
Customer Service Department 1-866-972-6168
www.primaltreestands.com
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
©2020 (rev. 1/20)
