Prima FIT I Installation Instruction Download

Page: 5 / 16

IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for fixtures.

Prima is not responsible for any fixture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on

which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties

are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult

our customer service department with any questions regarding dimmer specifics. Prima is not responsible for any damage caused by improper

dimmer specification and usage. Use only qualified electrician for installation. Adhere to all local and national electrical codes prior to installation.

It is strongly recommended that gloves are used when handling the FIT I System track. Oils and dirt from fingers can sometimes permanently

mark the finish. Track should be cleaned with a damp cloth and thoroughly dried before fixture installation.

FIT I System adapter are installed in the track using a twist-and-lock method. The adapter is inserted at the desired location on the track

length. Pressure is applied on the adapter to compress the internal contact/pressure mechanism. While applying said pressure, the

adapter is rotated 90º clockwise until it stops. To secure the adapter, the knurled locking ring is rotated clockwise by hand until sufficient pressure

creates a solid and secure mounting. IMPORTANT: Do not attempt to slide the adapter to other locations on the track length after it is installed. The

adapter must be completely removed from the track slot and reinstalled at the new location.

Insert the adapter into the

track slot

Apply pressure and

rotate 90º clockwise

After rotation,

adapter rests

inside track slot.

Rotate knurled

locking ring

clockwise to

secure the adapter.

There should now

be a gap between

the two knobs.

Ensure that there is

no gap between

the knurled knobs

before installation.

Rotate knurled

locking ring

clockwise to

secure the adapter.

There should now

be a gap between

the two knobs.

Ensure that there is

no gap between

the knurled knobs

before installation.

FIT I SYSTEM TRACK REQUIRES SUPPORT POINTS BE INSTALLED EVERY 4’

l mounted

support. The following steps cover the general task of inserting the support adapter into the track slot. See the individual steps for various

support method installation instructions. It is strongly recommended that gloves are used when handling the FIT I System track. Oils and dirt

from fingers can sometimes permanently mark the finish. Track should be cleaned with a damp cloth and thoroughly dried before fixture

installation.

FIT I System support adapters are installed in the track using a twist-and-lock method. The support adapter is inserted at the desired

location on the track length. The adapter is rotated 90º clockwise until it stops. With a stem suspended support adapter, it will be

necessary to SLIGHTLY loosen the stem coupler to allow the adapter to rotate and lock into the track slot. To secure the adapter, the knurled

locking ring is rotated clockwise by hand until sufficient pressure creates a solid and secure mounting. IMPORTANT: Do not attempt to slide the

adapter to other locations on the track length after it is installed. The adapter must be completely removed from the track slot and reinstalled at the

new location.

Insert the support adapter

into the track slot

Loosen the set screw with

the supplied hex wrench.

(for stem only)

Rotate the adapter 90º

until the track rests on

the adapter.

Tighten the set screw

with the hex wrench.

(for stem only)