fit I system wall support for vertical orientated track only
Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
G
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for fixtures.
Prima is not responsible for any fixture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult
our customer service department with any questions regarding dimmer specifics. Prima is not responsible for any damage caused by improper
dimmer specification and usage. Use only qualified electrician for installation. Adhere to all local and national electrical codes prior to installation.
It is strongly recommended that gloves are used when handling the FIT I System track. Oils and dirt from fingers can sometimes permanently
mark the finish. Track should be cleaned with a damp cloth and thoroughly dried before fixture installation.
Be sure that the items indicated below are included in the package. Mount screw anchors in the mounting surface so that they align with
the holes in the mounting disks. Secure the mounting disks to the mounting surface with the included screws.
45º
Cable support
mounting disk
should be placed at
a 45º angle from the
end of the stem.
Further
adjustment
may be
necessary for
leveling the
stem.
Hex Wrench
Track locking knob
Mounting Screws & Anchors
Mounting Screws & Anchors
Support Stem Assembly
Cable support mounting disk
Insert one end of the support cable into the opening on the cable support mounting disk as shown. Continue to feed the cable through allowing the
cable to pass out the top hole of the cable holder. When sufficient tension is achieved to allow a level stem installation, tighten the set screw on the
cable holder with the hex wrench to lock the support cable in place. Further adjustment may be necessary at the end of the installation process.
Repeat the steps above for post installation adjustment.
Secure the track with the track locking knob. Insert the knob into the large hole on the top of the track bracket. Rotate the track locking knob 90º
clockwise to lock the track. Secure the locking knob by tightening the lower knob until there is no slack and the connection to
90º clockwise
G1
G2
G5
G6
G7
G3
G4
Feed excess cable
through the top hole
Tighten lower knob
Insert the track into the track bracket by resting the bottom slot on the
grip teeth. Then twist the track into position as shown below.
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
REV
.033015
prima fit I system
general installation instructions part 5 of 12
